Water Heater Installation & Replacement
Swap a dead tank for a new one and choose capacity, fuel type, venting and placement.
New gas to a range, dryer, grill, fire pit or fireplace, or a repair on piping that has corroded or been struck. Gas work follows strict rules, and the first rule is safety. Notice a rotten-egg odor? Walk everyone outside first, then dial 911 or the gas utility from the yard.
Smelling gas means getting everyone out and contacting 911 or the gas utility away from the building.
Gas plumbers run black iron, CSST or copper-tube piping to appliances, install shutoff valves and drip legs where required and test the system for leaks. They also reconnect appliances after a move or a replacement.
Common jobs are a new line to an outdoor kitchen or fire pit, a dryer hookup, a stove replacement and converting between natural gas and propane.
After any gas work the system is pressure-tested. The plumber pressurizes the line with air or gas and watches the gauge for loss. A soap solution on joints shows small leaks as bubbles.
Westminster lists gas lines among work that needs a permit, both inside and outside the house. The inspector checks the work before it is covered and again when it is finished.
Gas jobs are priced by length, material and permit. These items matter.
Ask who pulls the permit and whether the quote includes the pressure test.
Before any excavation for a gas line, call 811 so utilities can mark buried lines. Natural gas in this area is commonly supplied by the local utility, which should be called for service-side problems.
A gas line to a detached grill or fire pit is buried below the frost depth and sleeved where required. Ask the contractor about depth and marking tape.
Gas has a rotten-egg odor added so people notice a leak. Other signs include a hissing sound near a pipe, dead vegetation over a buried line and a pilot that keeps going out.
Carbon monoxide detectors protect against incomplete combustion. Place them near sleeping areas and test them often.
Flexible connectors are common on ranges and dryers. They should be new, the right length and rated for the appliance. A connector that is kinked or corroded is a leak waiting to start.
At high altitude, gas appliances must be set up for the elevation. A burner that runs yellow or sooty is a sign that something is off.
These steps keep the job safe.
Swap a dead tank for a new one and choose capacity, fuel type, venting and placement.
Flush scale, repair or put in an on-demand heater.
Rough-in and trim-out plumbing for a new house, a finished basement or an addition.
Walk out immediately, leave switches and flames alone, and reach 911 or the utility's emergency line once you are well away from the building.
Westminster lists gas lines among work that needs a permit. Your contractor should handle it.
Moving a gas appliance involves reconnecting the line, which is work for a qualified person. A leak can be dangerous.
Appliances need a conversion kit and the regulator must change. A qualified technician handles it.
Step outside right away and keep clear of light switches and flames. Reach 911 or the gas utility from the yard. When the utility has made things safe, call the dispatcher to arrange piping repairs or replacement.
Get out first and dial 911 or the gas utility from a distance. Once the supply is secure, phone us to book the repair.
Service area centered on Westminster and the nearby Denver north-metro cities.